System Description: Notes
- Wiper switch (combination switch) is composed of a combination of 5 output terminals and 5 input terminals. Terminal combination status is read by BCM when switch is turned ON.
- BCM controls rear wiper ON and INT (intermittent) operation.
- Power supplied all time
- through 50 A fusible link (letter M, located in fusible link block)
- to BCM terminal 55
- through 15 A fuse [No. 22, located in fuse block (J/B)]
- to BCM terminal 42.
- When ignition switch ON or START position, power is supplied
- Through 15 A Fuse [No. 1, Located In Fuse Block (J/B)]
- To BCM Terminal 38,
- Through 10 A Fuse [No. 84, Located In IPDM E/R (Intelligent Power Distribution Module Engine Room)]
- To Rear Washer Motor Terminal 1.
- Ground is supplied
- To Bcm Terminals 49 And 52
- Through Body Grounds M35, M45 And M85
- To Combination Switch (Wiper Switch) Terminal 12
- Through Body Grounds M35, M45 And M85.