Removal And Installation Of Rear Wiper Arm, Adjustment Of Wiper Arms Stop Location: Installation

1. Prior to wiper arm installation, turn on wiper switch to operate wiper motor and then turn it "OFF" (auto stop).
2. Lift the blade up and then set it down onto glass surface to set the blade center to clearance "L" immediately before tightening nut.
3. Eject washer fluid. Turn on wiper switch to operate wiper motor and then turn it "OFF".
4. Ensure that wiper blades stop within clearance "L".
   1. Clearance "L" : 45 - 60 mm (1.77 - 2.36 in) 
   • Tighten wiper arm nuts to specified torque.
     1. Rear wiper arm nut : 5.0 N.m (0.51 kg-m, 44 in-lb) 
     Fig 1: Displaying Clearance L

     Courtesy of NISSAN MOTOR CO., U.S.A.

Install in the reverse order of removal.