Check Power Supply And Ground Circuit

Check fuse
- Check if wiper and washer fuse is blown.
Fig 1: Checking Fuse Location
Courtesy of NISSAN MOTOR CO., U.S.A.

Refer to WIRING DIAGRAM - WIPER .

OK or NG
1. OK: GO TO 2 .
2. NG: If fuse is blown, be sure to eliminate cause of problem before installing new fuse. Refer to:
  - For FX35, see POWER DISTRIBUTION .
  - For FX45, see POWER DISTRIBUTION .
Check power supply circuit
1. Disconnect BCM connector.
2. Check voltage between BCM harness connector terminal and ground.
  
  Fig 2: Checking BCM Voltage Circuit
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  Fig 3: Displaying Power Supply Circuit Specifications
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK: GO TO 3 .
2. NG: Check harness for open or short between fuse, fusible link and BCM.
Check ground circuit
Check continuity between BCM harness connector M4 terminals 49 (B), 52 (B) and ground.
1. 49 (B), 52 (B) - Ground : Continuity should exist.
OK or NG
1. OK: INSPECTION END
2. NG: Repair harness or connector.
Fig 4: Checking Ground Circuit
Courtesy of NISSAN MOTOR CO., U.S.A.