CONSULT-II Operation

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn the ignition switch ON.

Fig 1: Locating Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "START (NISSAN BASED VHCL)".

Fig 2: Displaying CONSULT-II Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM" on "SELECT SYSTEM" screen.
If "BCM" is not indicated, see following:
- For FX35, see COMPUTER DATA LINES .
- For FX45, see COMPUTER DATA LINES .
Fig 3: Locating BCM On Select System Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "WIPER".

Fig 4: Locating Wiper In Select System Screen
Courtesy of NISSAN MOTOR CO., U.S.A.