Exterior & Interior - Body & Trim: Sunroof: Adjustment

Install motor & limit SW assembly and sunroof rail assembly in the following sequence: 

1. Arrange equal lengths of link and wire assemblies on both sides of sunroof opening.
2. Connect sunroof connector to sunroof switch and positive (+) power supply.
3. Set lid assembly to fully closed position[A] by operating OPEN switch and TILT switch.
4. Fit outer side of lid assembly to the surface of roof on body outer panel.
5. Press TILT-UP switch to check lid assembly for normal tilting.
6. Check sunroof lid assembly for normal operations (tilt-up, tilt-down, open, and close).
   Fig 1: Adjusting Sunroof

   Courtesy of NISSAN MOTOR CO., U.S.A.