| No lamps operate (including headlamps). |
- Check 10A fuse [No. 6, located in fuse block (J/B) NO.1]. Verify battery positive voltage is present at terminal 7 of headlamp battery saver control unit.
- Check lighting switch. Refer to
.
- Check headlamp battery saver control unit. Refer to
.
|
| No parking, side marker, license and tail lamps operate, but headlamps do operate. |
- Check 15A fuse [No. 54, located in fuse, fusible link and relay block (J/B)]. Verify battery positive voltage is present at terminals 6 and 2 of tail lamp relay.
- Check tail lamp relay.
- Check harness between headlamp battery saver control unit terminals 6 and 14 and tail lamp relay terminal 1. Check harness between tail lamp relay terminal 7 and terminals of each combination lamp.
- Check lighting switch. Refer to
.
- Check harness between lighting switch terminal 11 and headlamp battery saver control unit terminals 5 and 13. Check harness between lighting switch terminal 5 and ground.
- Check headlamp battery saver control unit. Refer to
.
|
| Battery saver control does not operate properly. |
- Check RAP signal. Verify 12 positive voltage from BCM is present at terminal 10 of headlamp battery saver control unit:
- Within 45 seconds after ignition switch turned off.
- Front door is opened or more than 45 seconds after ignition switch is turned off.
- Check the following.
- Harness between BCM and front door switch (driver side) or front door switch (passenger side) for open or short circuit.
- Front door switch (driver side) or front door switch (passenger side) ground circuit.
- Front door switch (driver side) or front door switch (passenger side).
- Check the following.
- Harness between headlamp battery saver control unit terminals 5 or 13 and lighting switch terminal 11 for open or short circuit.
- Harness between lighting switch terminal 5 and ground.
- Lighting switch. Refer to
.
- Check headlamp battery saver control unit. Refer to
.
- Check BCM. Refer to
.
|