Front Turn Signal And Parking (Clearance) Lamp
- Turn the lighting switch to OFF position.
- Remove the mass air flow sensor cover and the air cleaner assembly (when replacing LH bulb). Refer to AIR CLEANER AND AIR DUCT in ENGINE MECHANICAL - 4.5L V8 article.
- Remove the battery cover and the battery (when replacing RH bulb). Refer to REMOVAL AND INSTALLATION in BATTERY article.
- Turn the bulb socket counterclockwise and unlock it.
- Remove the bulb from its socket.
- Headlamp (outer side), for low beam: 12V 35W (D2R)
- Headlamp (inner side), for high beam: 12V 60W (HB3) (#9005)
- Front turn signal and parking lamp: 12V 27/8W (amber)
CAUTION:
After installing the bulb, be sure to install the plastic cap and the bulb socket securely to ensure water-tightness.