Body & Trim - Exterior & Interior: Sunroof: Adjustment

Install motor & limit SW assembly and sunroof rail assembly in the following sequence:

1. Arrange equal lengths of link and wire assemblies on both sides of sunroof opening.
2. Connect sunroof connector to sunroof switch and positive (+) power supply.
3. Set lid assembly to fully closed position "A" in Fig 1 by operating OPEN switch and TILT switch. After the lid has closed all the way, keep pushing the tilting switch toward tilt DOWN for more than 1 second.
   Fig 1: Adjusting Sunroof Lid Assembly

   Courtesy of NISSAN MOTOR CO., U.S.A.
4. Fit outer side of lid assembly to the surface of roof on body outer panel.
5. Press TILT-UP switch to check lid assembly for normal tilting.
6. Check sunroof lid assembly for normal operations (tilt-up, tilt-down, open, and close).