System Description: Notes

The parking, license and tail lamp operation is controlled by the lighting switch which is built into the combination switch and smart entrance control unit. The battery saver system is controlled by the smart entrance control unit.

1. Power is supplied at all times
   • to tail lamp relay terminals 1 and 3
   • through 10A fuse (No. 60, located in the fuse and fusible link box), and
   • to smart entrance control unit terminal 49
   • through 10A fuse [No. 13, located in the fuse block (J/B)].
2. When ignition switch is in ON or START position, power is supplied
   • to smart entrance control unit terminal 27
   • through 10A fuse [No. 10, located in the fuse block (J/B)].
3. When the ignition switch is in the ACC or ON position, power is supplied
   • to smart entrance control unit terminal 26
   • through 10A fuse [No. 1, located in the fuse block (J/B)].
4. Ground is supplied to smart entrance control unit terminals 43 and 64.
   • through body grounds M9, M25 and M87.