AWD Warning Lamp Does Not Illuminate With Ignition Switch On.

CHECK CAN COMMUNICATION LINE
WITH CONSULT-II

Perform the self-diagnosis. Is a malfunction in the CAN communication indicated in the results?

NOTE: If self-diagnosis is not carried out, check power supply and ground. Refer to "CONTROL UNIT POWER SUPPLY AND GROUND ".

YES or NO
1. YES: Check the CAN communication line. Refer to "CAN COMMUNICATION SYSTEM ".
2. NO: GO TO 2.
CHECK AWD WARNING LAMP CIRCUIT
1. Turn ignition switch "OFF".
2. Check the combination meter.
  Refer to COMBINATION METERS .
OK or NG
1. OK: GO TO 4.
2. NG: GO TO 3.
DETECT MALFUNCTIONING ITEM
Check the following:
- 10A fuse [No. 14, located in the fuse block (J/B)]
- Harness for short or open between ignition switch and combination meter M20 terminal 7 (G/Y)
- Ignition switch. Refer to SYSTEM WIRING DIAGRAMS (FX35) or SYSTEM WIRING DIAGRAMS (FX45) .
OK or NG
1. OK: Replace the combination meter. Refer to REMOVAL & INSTALLATION .
2. NG: Repair or replace damaged parts.
SYMPTOM CHECK
Check again.

OK or NG
1. OK: INSPECTION END
2. NG: GO TO 5.
CHECK AWD CONTROL UNIT
1. Check AWD control unit input/output signal.
2. If NG, recheck AWD control unit pin terminals for damage or loose connection with harness connector.
OK or NG
1. OK: INSPECTION END
2. NG: Repair or replace damaged parts.