AWD Warning Lamp Does Not Go Out Several Seconds After Engine Started.(AWD Lock Indicator Lamp Goes Out.)

CHECK SELF-DIAGNOSTIC RESULTS
WITH CONSULT-II

Perform the self-diagnosis.

NOTE: If self-diagnosis is not carried out, check power supply and ground. Refer to "CONTROL UNIT POWER SUPPLY AND GROUND ".

Is any malfunction detected by self-diagnostic?
1. YES: Check the malfunctioning system.
2. NO: GO TO 2.
CHECK AWD WARNING LAMP CIRCUIT
1. Turn ignition switch "OFF".
2. Check the combination meter.
  Refer to COMBINATION METERS .
OK or NG
1. OK: GO TO 3.
2. NG: Replace the combination meter. Refer to REMOVAL & INSTALLATION .
SYMPTOM CHECK
Check again.

OK or NG
1. OK: INSPECTION END
2. NG: GO TO 4.
CHECK AWD CONTROL UNIT
1. Check AWD control unit input/output signal.
2. If NG, recheck AWD control unit pin terminals for damage or loose connection with harness connector.
OK or NG
1. OK: INSPECTION END
2. NG: Repair or replace damaged parts.