Removal and Installation: Installation
- Install mirror base as follows:
- Determine mirror base position on windshield by measuring from top of windshield to top of mirror base as shown in the figure.
- Mark location on outside of windshield with wax pencil or equivalent.
- Clean attaching point on inside of windshield with an alcohol-saturated panel towel.
- Sand bonding surface of mirror base with sandpaper (No. 320 or No. 360).
- Clean bonding surface of mirror base with an alcohol-saturated paper towel.
- Apply Genuine Mirror Adhesive (Refer to
"RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS
" or equivalent to bonding surface of mirror base.
- Install mirror base at premarked position and press mirror base against glass for 30 to 60 seconds.
- After five minutes, wipe off excess adhesive with an alcohol-moistened paper towel.
Courtesy of NISSAN MOTOR CO., U.S.A.
- Install rearview mirror.