Removal and Installation

Front door finisher 

1. Remove inside handle escutcheon. A
2. Remove power window switch finisher, then disconnect the connectors. B
3. Remove screw securing pull handle, and then remove pull handle.
4. Remove mask securing front door finisher. C
5. Remove screw securing front door finisher.
6. Remove clips securing front door finisher.
7. Lift out front door finisher. Disconnect harness connectors. D

   Rear door finisher 

8. Remove inside handle escutcheon. E
9. Remove power window switch finisher, then disconnect the connector. F
10. Remove screw securing pull handle, and then remove pull handle.
11. Remove clips securing rear door finisher.
12. Lift out rear door finisher. G
    Fig 1: Removing And Installing Door Trim (1 Of 2)

    Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 2: Removing And Installing Door Trim (2 Of 2)

    Courtesy of NISSAN MOTOR CO., U.S.A.