Washer Operation

When the rear wiper switch is turned to WASH position, ground is supplied

to rear wiper amp. terminal 1 through terminals 23 and 24

through body grounds E13 and E41.

Then, power is supplied

through rear wiper amp. terminal 7

to rear washer motor terminal 2.

Ground is supplied

to rear washer motor terminal 1

through body grounds E13 and E41.

With power and ground supplied, the rear washer motor operates.

When the rear wiper switch is turned to WASH position for one second or more, the rear wiper motor operates at low speed for approximately 3 seconds after the rear wiper switch is released. This feature is controlled by the rear wiper amp. in the same manner as the low speed operation.