Multi-Remote Control System Operation

Power is supplied at all times

through 15A fuse [No. 20, located in the fuse block (J/B)]

to multi-remote control relay terminals 1, 3 and 6.

Ground is supplied to multi-remote control relay terminal 2, when the multi-remote control system is triggered through the smart entrance control unit.

Refer to MULTI-REMOTE CONTROL SYSTEMS article .

The multi-remote control relay is energized.

Power is supplied through terminal 7 of the multi-remote control relay

to front fog lamp LH (turn signal) terminal 2

to combination meter terminal 25

to rear combination lamp LH terminal 5.

Power is supplied through terminal 5 of the multi-remote control relay

to front fog lamp RH (turn signal) terminal 2

to combination meter terminal 29

to rear combination lamp RH terminal 5.

Ground is supplied to terminal 3 of each front fog lamp (turn signal) through body grounds E13 and E41.

Ground is supplied to terminal 6 of the rear combination lamp LH through body grounds B11, B22 and D210.

Ground is supplied to terminal 6 of the rear combination lamp RH through body grounds B55 and B75.

Ground is supplied to combination meter terminal 30 through body grounds M4, M66 and M147.

With power and ground supplied, the smart entrance control unit controls the flashing of the hazard warning lamps.