Hazard Lamp Operation

Power is supplied at all times to hazard switch terminal 3 through:

15A fuse [No. 20, located in the fuse block (J/B)].

With the hazard switch in the ON position, power is supplied

through terminal 1 of the hazard switch

to combination flasher unit terminal 1

through terminal 3 of the combination flasher unit

to hazard switch terminal 4.

Ground is supplied to combination flasher unit terminal 2 through body grounds M4, M66 and M147.

Power is supplied through terminal 5 of the hazard switch to

front fog lamp LH (turn signal) terminal 2

combination meter terminal 25

rear combination lamp LH terminal 5.

Power is supplied through terminal 6 of the hazard switch to

front fog lamp RH (turn signal) terminal 2

combination meter terminal 29

rear combination lamp RH terminal 5.

Ground is supplied to terminal 3 of each front fog lamp (turn signal) through body grounds E13 and E41.

Ground is supplied to terminal 6 of the rear combination lamp LH through body grounds B11, B22 and D210.

Ground is supplied to terminal 6 of the rear combination lamp RH through body grounds B55 and B75.

Ground is supplied to combination meter terminal 30 through body grounds M4, M66 and M147.

With power and ground supplied, the combination flasher unit controls the flashing of the hazard warning lamps.