Washer Operation

With the ignition switch in the ACC or ON position, power is supplied

through 20A fuse [No. 19, located in the fuse block (J/B)]

to front washer motor terminal 1.

When the lever is pulled to the WASH position, ground is supplied

to front washer motor terminal 2

through terminal 18 of the front wiper switch

through terminal 17 of the wiper switch, and

through body grounds E13 and E41.

With power and ground supplied, the washer motor operates.

When the lever is pulled to the WASH position for one second or more, the wiper motor operates at low speed for approximately 3 seconds to clean windshield. This feature is controlled by the wiper amplifier in the same manner as the intermittent operation.