LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1992 >> G20 Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Overhaul - RL4F03A >> Component Disassembly & Reassembly >> Output Shaft & Gear, Idler Gear, Reduction Gear & Bearing Retainer >> Inspection

Output Shaft & Gear, Idler Gear, Reduction Gear & Bearing Retainer: Inspection

  1. Inspect output shaft for cracks, wear or damage. Check all gears for wear, chips and cracks. Ensure bearings roll freely and are free from noise, cracks, pitting or wear.
  2. Install NEW seal rings to output shaft and bearing retainer. Measure clearance between seal ring and ring grooves of output shaft and bearing retainer. Specified clearance is .004-.010" (.10-.25 mm). Service limit is .010" (.25 mm). If clearance is not as specified, replace output shaft or bearing retainer as necessary.
scientia non olet · About LEMON Manuals