LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1992 >> G20 Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [C] >> Removal & Installation >> Water Pump >> Removal & Installation

Removal & Installation

  1. Drain cooling system. Remove accessory drive belts. Remove retaining bolts and water pump. To install, ensure all sealing surfaces are clean.
  2. Apply bead of sealant to water pump, and install water pump. Tighten retaining bolts to specification. See TORQUE SPECIFICATIONS  .
  3. To install remaining components, reverse removal procedure. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals