LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1992 >> G20 Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [C] >> Removal & Installation >> Intake Manifold >> Installation

Intake Manifold: Installation

  1. To install intake manifold collector and intake manifold, reverse removal procedure using new gaskets. Tighten all bolts to specification in sequence. See Figure . See TORQUE SPECIFICATIONS  .
  2. When installing fuel rail and fuel injectors, use new insulators and "O" rings. Lubricate "O" rings with silicone oil before installing. Tighten fuel rail retaining bolts to specification in sequence. See Figure . See TORQUE SPECIFICATIONS  .
  3. Coat fuel hoses-to-fitting surface with small amount of silicone oil before installing. To install remaining components, reverse removal procedure. If cooling system was drained, fill and bleed cooling system. See COOLING SYSTEM BLEEDING  under REMOVAL & INSTALLATION.
NOTE: If accel-drum unit was removed or throttle chamber or rod were changed, install new rod and adjust accel-drum unit. See ACCEL-DRUM UNIT ADJUSTMENTS  .
scientia non olet · About LEMON Manuals