LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1992 >> G20 Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [C] >> Removal & Installation >> Cylinder Head >> Inspection

Cylinder Head: Inspection

  1. Inspect cylinder head warpage at cylinder block area. Replace or resurface cylinder head if warpage exceeds specification. See CYLINDER HEAD  table under ENGINE SPECIFICATIONS. Ensure cylinder head height is within specification after machining.
    CAUTION: DO NOT machine more than .008" (.20 mm) total from cylinder head and cylinder block deck surface.
  2. Measure distance from bottom of head to end of bolt on all cylinder head-to-cylinder block bolts. Cylinder head bolt must be replaced if distance exceeds 6.228" (158.19 mm).
scientia non olet · About LEMON Manuals