LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 1992 >> G20 Automatic >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Axle Shafts - Front >> Removal & Installation >> Fwd Axle Shaft >> Removal (Outer CV Joint)

Removal (Outer CV Joint)

  1. Remove and discard boot bands. Slide boot off joint housing. Thread wheel bearing lock nut onto joint. Using a slide hammer and bearing puller, remove joint from axle shaft. See Fig 1 .
  2. Remove circlip from end of axle, and remove boot. If boot is being reused, take care not to cut boot on axle splines during removal. Clean CV joint in suitable solvent. Inspect components, and replace joint if necessary.
    Fig 1: Removing Outer CV Joint
    G92G00246Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals