Installation (Axle Shaft)
- Install new oil seal in transaxle (if required). Install Seal Protector (KV38106800
or J34297
) into seal. See Fig 1
. Insert axle shaft into transaxle and engage splines into side gear. Remove seal protector.
- Seat axle fully into transaxle, ensuring circlip engages groove in side gear. Test for proper installation by pulling outward on CV joint. DO NOT
pull on axle shaft. Axle is properly seated if CV joint will not pull free. To complete installation, reverse removal procedure.
Courtesy of NISSAN MOTOR CO., U.S.A.