Fuel Gauge: G20
- To check power source, turn ignition on. Check voltage between terminal No. 25 and ground. See Fig 1
. If battery voltage is present, go to step 3).
- If battery voltage is not present, check for blown fuse or fusible link. Check continuity between battery terminal and combination meter. Check battery circuit from ignition switch and relay. See appropriate wiring diagram in the WIRING DIAGRAMS Section.
- Turn ignition switch on. Connect a test light with 3.4 watt bulb between fuel gauge terminal "B(1)" and ground. See Fig 2
. If gauge needle does not move smoothly to FULL, replace gauge. If needle moves smoothly to FULL, check continuity between combination meter terminal No. 6 and ground. See Fig 3
. If continuity is not present, repair or replace wire harness between combination meter and fuel gauge unit.
- If continuity is present, test fuel tank sending unit. See FUEL TANK SENDING UNIT
under TESTING.
Courtesy of NISSAN MOTOR CO., U.S.A.
Courtesy of NISSAN MOTOR CO., U.S.A.
Courtesy of NISSAN MOTOR CO., U.S.A.