Verification of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

1. Connect GDS to Data Link Connector (DLC), and monitor "Diagnostic Trouble Codes (DTC)".
2. Clear all DTC in the system with GDS.
3. Operate system or vehicle within DTC detecting condition in DTC Detecting Condition chart.
4. Monitor "Diagnostic Trouble Codes (DTC)" with GDS and verify that any DTC is stored.
5. Are any DTCs stored in the system?

   YES 

   • Go to the applicable troubleshooting procedure.

   NO 

   • Problem is corrected and the system operation performs to specification at this time.