Battery, Power Window and Sunroof Reset

During open/close the power window, sunroof, battery (-) cable is removed or installed, or the fuse is replaced initialization of power window should be performed due to the erasure of default motor value.

POWER WINDOW AND SUNROOF RESET PROCEDURES

System	Resetting
Auto up/down window	Information You need to reset the window motor to its default settings for the following cases: During open/close the power windows, in case of not providing battery power connected power window due to the battery replacement, battery discharge and fuse replacement. Whenever the battery is disconnected, discharged or the related fuse is replaced or reinstalled, reset the Auto up/down window system according to the procedure below. Turn the ignition switch to the ON position. Pull up the power window switch in order that the window can close completely, and then keep pulling up the power switch for about 1 second.
Panoramaroof	During open/close the sunroof, battery power is not provided or discharged, or relevant fuse is replaced, or sunroof is activated using emergency handle, sunroof should be initialized as follows. Information During open/close the sunroof, in case of not providing battery power connected sunroof motor due to the battery replacement, battery discharge and fuse replacement. The automatic opening or closing of the sunroof, a one-touch feature, does not function properly. The sunroof reopens during automatic closing even if there is no object caught in the sunroof (safety feature) After IG ON, use CLOSE Switch to fully close the sunroof glass and roller blind. When the glass and the roller blind is fully closed, release the CLOSE Switch and then press and hold down the switch (about 10 sec.) until the glass and the blind moves slightly one time. Release the CLOSE Switch and then press and hold down the switch again, and the glass and the blind opens and closes in below order and completes Sunroof Reset process. Blind slides open → Sunroof glass tilts, slides open, and then closes → Blind slides and closes. * If the CLOSE Switch is released while above operation is in progress, the reset process is cancelled and you must go back and repeat the process from step 1.

System

Resetting

Auto up/down window

Information
You need to reset the window motor to its default settings for the following cases:

During open/close the power windows, in case of not providing battery power connected power window due to the battery replacement, battery discharge and fuse replacement.

Whenever the battery is disconnected, discharged or the related fuse is replaced or reinstalled, reset the Auto up/down window system according to the procedure below.

Turn the ignition switch to the ON position.
Pull up the power window switch in order that the window can close completely, and then keep pulling up the power switch for about 1 second.

Panoramaroof

During open/close the sunroof, battery power is not provided or discharged, or relevant fuse is replaced, or sunroof is activated using emergency handle, sunroof should be initialized as follows.
Information

During open/close the sunroof, in case of not providing battery power connected sunroof motor due to the battery replacement, battery discharge and fuse replacement.
The automatic opening or closing of the sunroof, a one-touch feature, does not function properly.
The sunroof reopens during automatic closing even if there is no object caught in the sunroof (safety feature)

After IG ON, use CLOSE Switch to fully close the sunroof glass and roller blind.
When the glass and the roller blind is fully closed, release the CLOSE Switch and then press and hold down the switch (about 10 sec.) until the glass and the blind moves slightly one time.
Release the CLOSE Switch and then press and hold down the switch again, and the glass and the blind opens and closes in below order and completes Sunroof Reset process.
Blind slides open → Sunroof glass tilts, slides open, and then closes → Blind slides and closes.

* If the CLOSE Switch is released while above operation is in progress, the reset process is cancelled and you must go back and repeat the process from step 1.