LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Veloster N Automatic DCT Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Diagnosis (1 Of 2) >> DTC B1384-00: Side Airbag Front-Passenger Resistance Circuit Short To Ground >> Wiring Inspection >> Squib Circuit Inspection

Squib Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect (-) terminal cable from battery and wait for 1 minutes or more.
  3. Disconnect PSAB module and connect the dummy (0957A-38200) and dummy adapter (0957A-3F000) to main harness connector.
    NOTE: If dummy and dummy adaptor are not able to be prepared, use a known-good PSAB or 2Ω resistor.
  4. Connect (-) terminal cable to battery and Ignition "ON" & Engine "OFF" and wait for 30 seconds or more.
  5. Connect GDS to Data Link Connector (DLC) and clear DTC with GDS and diagnose again.
  6. Is DTC present problem??

    YES 

    NO 

    • Substitute a known-good PSAB assembly, and check for proper operation. If the problem is corrected, replace PSAB and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals