Main harness Circuit Inspection
| Item | Normal value | Prerequisite condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Main harness Circuit Inspection (Ω) | Below 1Ω |
|
"High"/"Low" terminal of the Passenger airbag active vent harness connector | "High"/"Low" terminal of the Passenger airbag active vent harness connector |
*Measure the resistance at both ends of the terminal "High" and "Low"
WARNING:
Lay Removed PAB facing upward for unexpected air bag deploy.
- Is the measured resistance within specifications?
YES
- Substitute a known-good SRSCM, and check for proper operation. If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute the SRSCM main harness and check for proper operation. If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.