Main harness Circuit Inspection
| Item | Normal value | Prerequisite condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Main harness Circuit Inspection (V) | 0V |
|
"Low" terminal of the DBPT harness connector | Chassis ground |
| "High" terminal of the DBPT harness connector |
- Is the measured voltage within specifications?
YES
- Substitute a known-good SRSCM, and check for proper operation. If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute the SRSCM main harness and check for proper operation. If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.