LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Veloster N Automatic DCT Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag Diagnosis (1 Of 2) >> DTC B1333-00: FIS (Front Impact Sensor)-Passenger Defect >> DTC Information And Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Ignition "OFF", connect GDS.
  2. Ignition "ON" & Engine "OFF", select "Diagnostic Time Trouble Codes (DTC)" mode.
  3. Monitor Diagnostic Time trouble code and present of trouble code.
  4. Using a GDS, clear the DTC.
  5. Is DTC present problem?

    YES 

    • Go to "W/Harness Inspection" procedure.

    NO 

    • Displaying nothing (no DTC) or DTC with label "H" (historical) shows that Fault is intermittent caused by poor contact in the part's and/or SRSCM connector or was repaired and SRSCM memory was not cleared.
    • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.