LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Veloster 2.0, Standard Trans >> Repair and Diagnosis (Single Page) >> Brakes >> Anti-Lock Brakes >> Anti-Lock Brake System (Abs) >> Troubleshooting >> Even After The Engine Is Started, The ABS Warning Lamp Remains ON >> Check The CAN Circuit Wiring For ABS Warning Lamp

Check The CAN Circuit Wiring For ABS Warning Lamp

  1. Disconnect the instrument cluster connector (M08) and ABS HECU connector, and then turn the ignition switch OFF.
  2. Check for continuity between terminal (M08) 32 of the cluster harness side connector and terminal 26 of ABS HECU harness side.

    Check for continuity between terminal (M08) 33 of the cluster harness side connector and terminal 14 of ABS HECU harness side.

    Specification  : Below 1Ω

  3. Is resistance within specification?

    YES 

    • Repair short of wiring between terminal 26, 14 of ABS HECU harness connector and ABS warning lamp module.

    NO 

    • Repair open of wiring between terminal 26, 14 of ABS HECU harness connector and ABS warning lamp module.
scientia non olet · About LEMON Manuals