Wire Harness Inspection
| Item | Normal Value | Prerequisite Condition | Connector (+) | Connector (-) |
|---|---|---|---|---|
| Power circuit (ground short): resistance | Infinite |
|
Bumper Antenna power terminal | Chassis ground |
| Power circuit (open): resistance | Approx. below 1 Ω | Bumper Antenna power terminal | SMK ECU's Bumper Antenna power terminal | |
| Ground circuit (open): resistance | Approx. below 1 Ω |
|
Bumper Antenna ground terminal | Chassis ground |
- Is the result within specifications?
YES
- Replace the Bumper Antenna with an usable test sample and check for proper operation. If it works properly, put the new component in place. Then, go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Inspect the power circuit for an open or short or the ground circuit for an open. Repair relevant component(s) as necessary and then go to "VERIFICATION OF VEHICLE REPAIR ".