C-CAN Terminal Resistor Inspection
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| CAN communication line: resistance | Approx. 60Ω |
|
FCA CAN High terminal | FCA CAN Low terminal |
| Approx. 120Ω |
|
PCM CAN High terminal | PCM CAN Low terminal |
- Is the result within specifications?
YES
- This can be an intermittent fault caused by poor contact in the sensor's and/or control module's connector. Or, control module's memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage.
- Repair or replace the relevant component(s) as necessary, and go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Go to next procedure.