Repair Procedures: Replacement
CAUTION:
- Put on gloves to prevent hand injuries.
Information
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
- Take care not to bend or scratch the trim and panels.
- Remove the crash pad lower panel.
(Refer to Crash Pad - "CRASH PAD LOWER PANEL ")
- After loosening the mounting screws, remove the lower switch assembly (A).
- Disconnect the lower switch connector (A).
- Using a screwdriver or remover, remove the steering column shroud upper panel (A).
- Using a screwdriver or remover, remove the cluster fascia panel (A).
- To install, reverse the removal procedure.
Information
- Replace any damaged clips (or pin-type retainers).