Section 22 (Automatic Transaxle System - General Information - 2.0L): Specifications: Notes

Item		Specifications
Engine type		Gasoline 2.0 GDI
Transaxle type		A6MF1	A6MF1-1
Drive system		4WD	2WD
Gear ratio	1st	4.612	4.440
	2nd	2.575	2.726
	3rd	1.772	1.834
	4th	1.369	1.392
	5th	1.000	1.000
	6th	0.778	0.774
	Reverse	3.500	3.440
Final gear ratio		3.648	3.510
Torque converter type		3-element, 1-stage, 2-phase type
Torque converter size		Ø236 mm (9.291 in.)
Oil pump system		Mechanical internal gear pump
Friction elements		Clutch: 2EA
		Brake: 3EA
		OWC: 1EA
Planetary gear		3EA
Fluid pressure balance piston		2EA
Accumulator		4EA
Solenoid valve		8EA (VFS:6EA, ON/OFF:2EA)
Shift lever position		4 Range (P, R, N, D)
Oil filter		1EA

VFS: Variable Force Solenoid

Sensors 

Input Speed Sensor 

• Type: Hall effect sensor
• Specifications

Item		Specifications
Operation condition (°C)°F		(-40 to 150) -40 to 302
Output voltage (V)	High	1.18 - 1.68
	Low	0.59 - 0.84

Output Speed Sensor 

• Type: Hall effect sensor
• Specifications

Item		Specifications
Operation condition (°C)°F		(-40 to 150) -40 to 302
Output voltage	High	1.18 - 1.68
	Low	0.59 - 0.84

Oil Temperature Sensor 

• Type: Negative Thermal Coefficient (NTC)
• Specifications

Temp.[(°C)°F]	Resistance (kΩ)
(-40) -40	48.1
(-20) -4.0	15.6
(0) 32.0	5.88
(20) 68.0	2.51
(40) 104.0	1.19
(60) 140.0	0.61
(80) 176.0	0.32
(100) 212.0	0.18
(120) 248.0	0.11
(140) 284.0	0.07
(160) 320.0	0.04

Switch 

Inhibitor Switch 

• Type: Combination of output signals from 4 terminals
• Specifications

Item	Specifications
Power supply (V)	12
Output type	Combination of output signals

Solenoid Valves 

Clutch/Brake control VFS [26/B, T/CON]

• Control type: Normally low type

Item	Specifications
Control Pressure [kpa (kgf/cm, psi)]	9.81 - 500.14 (0.1 - 5.1, 1.42 - 72.54)
Current value (mA)	50 - 850
Internal resistance (Ω)	5.1 ± 0.3

Clutch/Brake control VFS [UD/B, OD/C, 35R/C]

• Control Type: Normally high type

Item	Specifications
Control Pressure [kpa (kgf/cm, psi)]	500.14 - 9.81 (5.1 - 0.1, 72.54 - 1.42)
Current value (mA)	850 - 50
Internal resistance (Ω)	5.1 ± 0.3

Line Pressure Control VFS [Line pressure]

• Control type: Normally high type

Item	Specifications
Control Pressure [kpa (kgf/cm, psi)]	500.14 - 9.81 (5.1 - 0.1, 72.54 - 1.42)
Current value (mA)	850 - 50
Internal resistance (Ω)	5.1 ± 0.3

ON/OFF Solenoid Valve (SS-A, SS-B)

• Control type: Normally low type

Item	Specifications
Control Pressure [kpa (kgf/cm, psi)]	490.33 (5.0, 71.12)
Internal resistance (Ω)	10 - 11

Item	SS-A	SS-B	UD/B-VFS	OD/C-VFS	35R/C-VFS	26/B-VFS
			N/H	N/H	N/H	N/L
N, P	(1)		(1)		(1)
1	(2)			(2)	(1)
2				(1)	(1)	(1)
3		(1)		(1)
4					(1)
5		(1)	(1)
6			(1)		(1)	(1)
L	(1)				(1)
R	(1)	(1)	(1)
(1) Connected status (2) Connected at vehicle speed above 8km/h

Item	Tightening Torques
	N.m	kgf.m	lb-ft
Shift cable bracket mounting bolt	14.7 - 21.6	1.5 - 2.2	10.8 - 15.9
Fixing nut of shift cable in the manual lever	9.8 - 13.7	1.0 - 1.5	7.2 - 10.8
Automatic transaxle upper mounting bolt (TM=>Eng)	42.2 - 53.9	4.3 - 5.5	31.1 - 39.8
Automatic transaxle mounting bracket bolt	88.3 ~ 107.9	9.0 ~ 11.0	65.1 ~ 79.6
Automatic transaxle support bracket mounting bolt	58.9 - 78.5	6.0 - 8.0	43.4 - 57.8
Torque converter mounting bolt	45.1 - 52.0	4.6 - 5.3	33.3 - 38.3
Automatic transaxle lower mounting bolt (Eng=>TM)	42.2 - 48.1	4.3 - 4.9	31.1 - 35.4
	42.2 - 53.9	4.3 - 5.5	31.1 - 39.8
TCM mounting nut	9.8 - 11.8	1.0 - 1.2	7.2 - 8.7
Input shaft speed sensor mounting bolt	9.8 - 11.8	1.0 - 1.2	7.2 - 8.7
Output shaft speed sensor mounting bolt	9.8 - 11.8	1.0 - 1.2	7.2 - 8.7
Shift lever assembly bolt	8.8 - 13.7	0.9 - 1.4	9.4 - 10.8
Inhibitor switch mounting bolt	9.8 - 11.8	1.0 - 1.2	7.2 - 8.7
Valve body cover mounting bolt	11.8 - 13.7	1.2 - 1.4	8.7 - 10.1
Injection hole (eyebolt)	4.9 - 5.9	0.5 - 0.6	3.6 - 4.3
ATF drain plug	33.3 - 43.1	3.4 - 4.4	24.6 - 31.8
Starter mounting bolt	42.2 - 54.0	4.3 - 5.5	31.1 - 39.8