LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Tucson Ultimate, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Engine Starting System - 2.0L) >> Starter >> Repair Procedures >> Disassembly

Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the M-terminal (A) on the magnet switch assembly.
    G13016991Courtesy of HYUNDAI MOTOR AMERICA
  2. After loosening the screws (A), detach the magnet switch assembly (B).
    G13016992Courtesy of HYUNDAI MOTOR AMERICA
  3. Loosen the through bolts (A).
    G13016993Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the brush holder assembly (A), armature assembly (B) and yoke assembly (C).
    G13016994Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the gasket sheet (A) and lever stop (B).
    G13016995Courtesy of HYUNDAI MOTOR AMERICA
  6. Remove the reducer assembly (A) and lever (B).
    G13016996Courtesy of HYUNDAI MOTOR AMERICA
  7. Press the stopper (A) using a socket (B).
    G13016997Courtesy of HYUNDAI MOTOR AMERICA
  8. After removing the stop ring (A) using stop ring pliers (B).
    G13016998Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the stopper (A), overrunning clutch (B) and internal gear (C).
    G13016999Courtesy of HYUNDAI MOTOR AMERICA
    NOTE: Using a suitable pulling tool (A), pull the overrunning clutch stopper (C) over the stop ring (B).
    G13017000Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals