Component Inspection

Ignition "ON" & Engine "OFF" and Using a GDS, clear the DTC.
Ignition "OFF".
Disconnect the battery (-) terminal cable from the battery, and wait at least one minutes.
Disconnect OCS (Occupant Classification System) ECU connector.
Substitute the OCS (Occupant Classification System) ECU and check for proper operation.
Is DTC present problem?
YES
- Substitute a known-good SRSCM, and check for proper operation.
  If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute a known-good OCS (Occupant Classification System) ECU, and check for proper operation.
  If the problem is corrected, replace OCS (Occupant Classification System) ECU and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.