Front Muffler

WARNING: This page is about a different variant/trim than selected.

Disconnect the heated oxygen sensor connector (A) and then remove it from the bracket.

Courtesy of HYUNDAI MOTOR AMERICA
Remove the engine room under rear cover assembly (A).

Courtesy of HYUNDAI MOTOR AMERICA
Detach the rubber hanger (A) from the front muffler.
Remove the front muffler (B).
Tightening Torque:

39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- When installing, replace with new gaskets.
Install in the reverse order of removal.