Main Harness Circuit Inspection
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Main harness Circuit Inspection (V) | Battery Voltage |
|
Airbag warning lamp terminal of the Cluster harness connector | Chassis ground |
- Is the measured Voltage within specifications?
YES
- Check the warning lamp and connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Replace the cluster with a working one and check for proper operation. If it works properly, go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Check for an open/short in harness.
- Repair or replace relevant component(s) as necessary, and then go to "VERIFICATION OF VEHICLE REPAIR ".