LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Santa Fe Calligraphy, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System Diagnosis (Except HEV) (3 Of 3) >> DTC B1732-00: Anchor Pretensioner Front-Driver Resistance Circuit Short To Ground >> Wiring Inspection >> Squib Circuit Inspection

Squib Circuit Inspection

  1. Ignition switch OFF
  2. Disconnect the (-) terminal cable from the battery and wait for 1 minute or more.
  3. Disconnect the Anchor Pretensioner module and connect the dummy and dummy adapter to the Anchor Pretensioner harness connector.
    NOTE: If the dummy and dummy adaptor is not prepared, use a known-good Anchor Pretensioner or 2Ω resistor.
  4. Connect the (-) terminal cable to the battery and Ignition switch ON and the engine "OFF" and wait for 30 seconds or more.
  5. Connect the GDS to Data Link Connector (DLC) and clear the DTC with GDS and diagnose again.
  6. Is DTC present problem?

    YES 

    NO 

    • Substitute a known-good Anchor Pretensioner front-Driver assembly, and check for proper operation.

      If the problem is corrected, replace Anchor Pretensioner front-Driver and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

scientia non olet · About LEMON Manuals