Main harness Circuit Inspection
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Main harness Circuit Inspection (Ω) | Below 1 Ω |
|
"Low" terminal of the Anchor Pretensioner front-Driver harness connector. | "Low" terminal of the Anchor Pretensioner front-Driver harness connector. |
| "High" terminal of the Anchor Pretensioner front-Driver harness connector. | "High" terminal of the Anchor Pretensioner front-Driver harness connector. |
* Measure the resistance at both ends of the terminal "High" and "Low"
- Is the measured resistance within specifications?
YES
- Substitute a known-good SRSCM, and check for proper operation.
If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute the SRSCM main harness and check for proper operation.
If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute a known-good SRSCM, and check for proper operation.