Main Harness Circuit Inspection
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| Main harness Circuit Inspection (Ω) | Below 1Ω |
|
"High" terminal of the PSAB harness connector | "High" terminal of the PSAB harness connector |
| "Low" terminal of the PSAB harness connector | "Low" terminal of the PSAB harness connector |
* Measure the resistance at both ends of the terminal "High" and "Low"
The image file (SVG, SWF, GIF)
- Is the measured resistance within specifications?
YES
- Substitute a known-good SRSCM, and check for proper operation. If the problem is corrected, replace SRSCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute the SRSCM main harness and check for proper operation. If the problem is corrected, replace SRSCM main harness and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.