LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Santa Fe Calligraphy, AWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Airbag System Diagnosis (Except HEV) (1 Of 3) >> DTC B1117-00: B+ Line Disconnected >> DTC Information And Inspection >> Monitor GDS Data

Monitor GDS Data

  1. Ignition switch OFF, connect GDS.
  2. Ignition switch ON and the engine OFF, select "Current Data" mode.
  3. Monitor the "Battery Voltage" parameter on the GDS.

    Specification:  Battery voltage is between 8 and 16V

    G14538299Courtesy of HYUNDAI MOTOR AMERICA
  4. Is parameter displayed within specifications?

    YES 

    • Displaying no DTC or a DTC with a label "H" (historical) shows that the fault is intermittent caused by poor contact of the part's and/or SRSCM's connector. Or, the SRSCM memory was not cleared after repair. Thoroughly check the battery terminal and all connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
    • Repair as necessary, and then go to "VERIFICATION OF VEHICLE REPAIR ".

    NO 

    • Go to "W/Harness Inspection" procedure.
scientia non olet · About LEMON Manuals