LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Santa Fe Calligraphy, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Double Clutch Transmission System Diagnosis - 2.5T (4 Of 4) (Except HEV)) >> DTC P2858-97: Clutch 'B' Pressure Engagement Performance/Too Low >> Component Inspection >> S/W Management

S/W Management

WARNING: This page is about a different car, the 2022 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Connect GDS to "Data Link Connector (DLC)".
  2. Select the "Vehicle S/W Management" about related DTC with GDS.
  3. Select "TCU Neutralization" in S/W Management.
  4. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 5
CAUTION: Perform the following procedure for TCU, clutch pack replacement, TCU update, faulty TCU learning.

Fig.1 to 5) TCU Neutralization S/W Management Steps.

G14542956Courtesy of HYUNDAI MOTOR AMERICA
G14542957Courtesy of HYUNDAI MOTOR AMERICA
G14542958Courtesy of HYUNDAI MOTOR AMERICA
G14542959Courtesy of HYUNDAI MOTOR AMERICA
G14542960Courtesy of HYUNDAI MOTOR AMERICA
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Connect GDS to "Data Link Connector (DLC)".
  2. Select the "Vehicle S/W Management" about related DTC with GDS.
  3. Select diagnostic Air bleeding in S/W Management.
  4. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 4

Fig.1 to 4) Air bleeding S/W Management steps.

G14542961Courtesy of HYUNDAI MOTOR AMERICA
G14542962Courtesy of HYUNDAI MOTOR AMERICA
G14542963Courtesy of HYUNDAI MOTOR AMERICA
G14542964Courtesy of HYUNDAI MOTOR AMERICA
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Perform the diagnostic air bleeding function of S/W Management if necessary.
  2. Connect GDS to "Data Link Connector (DLC)".
  3. Select the "Vehicle S/W Management" about related DTC with GDS.
  4. Select air bleeding in S/W Management.
  5. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 4

Fig.1 to 4) Air bleeding S/W Management steps.

G14542965Courtesy of HYUNDAI MOTOR AMERICA
G14542966Courtesy of HYUNDAI MOTOR AMERICA
G14542967Courtesy of HYUNDAI MOTOR AMERICA
G14542968Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals