Monitor GDS Data

WARNING: This page is about a different car, the 2022 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.

Inspection Condition	Inspection Procedure	Reference
Ignition "ON".	Connect GDS to "Data Link Connector (DLC)". Engine "ON". Operate vehicle or system in accordance with enable condition in DTC detecting condition. Monitor "Input speed 1, 2", "Shift Lever Switch", "Current Gear" and "Engine RPM" parameter in "Current Data" with GDS.	Fig.1 to 8

Fig.1 to 8) Input shaft speed sensor ranges 1st through 8th gear.

G14542870

Courtesy of HYUNDAI MOTOR AMERICA

G14542871

Courtesy of HYUNDAI MOTOR AMERICA

G14542872

Courtesy of HYUNDAI MOTOR AMERICA

G14542873

Courtesy of HYUNDAI MOTOR AMERICA

G14542874

Courtesy of HYUNDAI MOTOR AMERICA

G14542875

Courtesy of HYUNDAI MOTOR AMERICA

G14542876

Courtesy of HYUNDAI MOTOR AMERICA

G14542877

Courtesy of HYUNDAI MOTOR AMERICA

Good

Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure.

No Good

Go to "WIRING INSPECTION " procedure.