LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Santa Fe Calligraphy, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Double Clutch Transmission System Diagnosis - 2.5T (3 Of 4) (Except HEV)) >> DTC P2722-11: Pressure Control Solenoid 'E' >> Component Inspection >> S/W Management

S/W Management

WARNING: This page is about a different car, the 2022 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Connect GDS to "Data Link Connector (DLC)".
  2. Select the "Vehicle S/W Management" about related DTC with GDS.
  3. Select "TCU Neutralization" in S/W Management.
  4. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 5
CAUTION: Perform the following procedure for TCU, clutch pack replacement, TCU update, faulty TCU learning.

Fig.1 to 5) TCU Neutralization S/W Management Steps.

G14540928Courtesy of HYUNDAI MOTOR AMERICA
G14540929Courtesy of HYUNDAI MOTOR AMERICA
G14540930Courtesy of HYUNDAI MOTOR AMERICA
G14540931Courtesy of HYUNDAI MOTOR AMERICA
G14540932Courtesy of HYUNDAI MOTOR AMERICA
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Connect GDS to "Data Link Connector (DLC)".
  2. Select the "Vehicle S/W Management" about related DTC with GDS.
  3. Select diagnostic Air bleeding in S/W Management.
  4. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 4

Fig.1 to 4) Air bleeding S/W Management Steps.

G14540933Courtesy of HYUNDAI MOTOR AMERICA
G14540934Courtesy of HYUNDAI MOTOR AMERICA
G14540935Courtesy of HYUNDAI MOTOR AMERICA
G14540936Courtesy of HYUNDAI MOTOR AMERICA
Inspection Condition Inspection Procedure Reference
  1. Start-up "ON".
  2. Shift lever P.
  3. Vehicle speed 0 km/h.
  4. Battery normal. (above 10V)
  5. NO DTC.
  1. Perform the diagnostic air bleeding function of S/W Management if necessary.
  2. Connect GDS to "Data Link Connector (DLC)".
  3. Select the "Vehicle S/W Management" about related DTC with GDS.
  4. Select air bleeding in S/W Management.
  5. After the final work, go to "Verification of Vehicle Repair" procedure.
 Fig.1 to 4

Fig.1 to 4) Air bleeding S/W Management Steps.

G14540937Courtesy of HYUNDAI MOTOR AMERICA
G14540938Courtesy of HYUNDAI MOTOR AMERICA
G14540939Courtesy of HYUNDAI MOTOR AMERICA
G14540940Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals