DTC Description
WARNING: This page is about a different car, the 2022 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
P1C2D03 is set when the HP EOP Motor Position Sensor*'s operation range is above 97% or below 3% of the specific range cause by the following fault.
When the detected fault during the 1st DC is still detected in the 2nd DC, DTC is confirmed and the TCU* outputs "MIL ON".
- Faulty HP EOP motor position sensor*
- Faulty HP EOP motor position sensor circuit*
| Driving Cycle*: DC | When [IG ON→Engine ON→IG ON] is performed, the Driving Cycle* 1time (1DC) is completed. |
| Component | Name_ETM | ETM |
|---|---|---|
| HP EOP Motor Position Sensor* | "ELECTRONIC OIL PUMP MOTOR"_Position Sensor | SD450-1 |
| TCU* | "TCM" |