LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Santa Fe Calligraphy, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Window Motors & Regulators >> Body Interior And Exterior - General Information (Except HEV) >> Troubleshooting

Body Interior And Exterior - General Information (Except HEV): Troubleshooting

Symptom Possible cause Counter measure
Wind noise around the door Arise the gap on weatherstrip Replace weatherstrip
Water leaks from panorama sunroof Miss install of panorama sunroof frame weather strip and deforming Replace
seal breakage Fill with sealant
Wind noise on Panorama Sunroof Deflector deformation and deviation Replace or Remounting
Noise while panorama sunroof is working (noise when opening or closing) Accumulation on the guide rail or rear rail Clean guide rail/rear rail and apply grease
Tilt lever shoe excessive wear and breakage Replace tilt lever shoe
Panorama Sunroof malfunction (Motor work, sunroof move partially or does not move Accumulation on the guide rail or rear rail
  1. Clean guide rail/rear rail and apply grease
2. Adjustment or replacement
Poor engagement drive cable and motor pinion. Adjustment or replacement
Sunroof operating resistance or interference (with cable, weather strip) increased. Adjustment or replacement
Motor initial value (position value) loss Motor Initialization
motor noise Poor engagement drive cable and motor pinion. NNN
Motor pinion gear worn out or breakage Motor Replacement
Drive cable worn out or breakage Replacement
Door glass inoperative Incorrect window glass installation Repositioning
Motor failure or regulator breakage/deformationDamaged or faulty motor and regulator Adjustment or replacement
Door does not open or close completely Door installation incorrect or striker/latch misalignment Adjust position
Breakage, deformation, incorrect installation on door handle and latch. Deformation of checker Adjustment or replacement
Not enough grease on door hinge and checker Apply grease
Hood does not open or close completely Striker and latch are not properly aligned. Adjustment
Hood installation incorrect Adjustment
Incorrect hood bumper height Adjustment
Water leak on windshield or rear window Defective seal Apply sealant
Defective flange Adjustment
Wiper blade wiping/vibration noise Glass surface contamination Remove the foreign matters and water-repellent coating using a clean wet towel.
Wiper blade contamination Clean wiper blade using a clean wet towel.
Improper wiper arm angle Check wiper arm angle specification and adjust.
Wiper blade worn out Wiper blade replacement.
Wiper blade failure Check if "tick" sound.
Wiper blade clearance Press the left and right sides of the blade using tools.