Monitor DTC Status
- Connect GDS and select the "DTC Analysis" mode.
- Click the "DTC Status" to check the DTC information.
- Read the "DTC Status" parameter, and Record all DTCs, DTC state and freeze frame data.
- Is the DTC active?
YES
- Go to the "WIRING INSPECTION " procedure.
NO
- This can occur when the HUD*'s memory was not cleared after the repair.
→ Go to the "VERIFICATION OF REPAIR " procedure.
- Inspect an intermittent fault caused by Poor Contact in the HUD*'s and/or a C-CAN communication unit/module's connector.
| Component | Name_ETM | ETM |
|---|---|---|
| HUD* | "HEAD UP DISPLAY" | SD200-2 |