LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2021 >> Ioniq Hybrid SEL >> Repair and Diagnosis >> Restraints >> Passive Restraints >> Seat Belt PRETENSIONER (HEV) >> Emergency Fastening Device (EFD) >> Repair Procedures >> Installation

Repair Procedures: Installation

  1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
  2. Install the emergency fastening device with the mounting bolt.

    Tightening torque: 

    39.2 - 53.9 N.m (4.0 - 5.5 kgf.m, 28.9 - 39.8 lb-ft)

  3. Connect the emergency fastening device connector (A).
    NOTE:
    • Make sure the lock pin is connected in properly.
  4. Install the floor carpet assembly.

    (Refer to Body - "FLOOR CARPET ")

  5. Install the center pillar trim.

    (Refer to Body - "Center Pillar Trim ")

  6. Install the door scuff trim.

    (Refer to Body - "Door Scuff Trim ")

  7. Connect the front seat belt to the emergency fastening device.
  8. Install the rear seat.

    (Refer to Body - "REAR SEAT ASSEMBLY ")

  9. Install the front seat.

    (Refer to Body - "FRONT SEAT ASSEMBLY ")

  10. Reconnect the battery negative cable.
  11. After installing the EFD system, confirm proper system operation:

    Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off.

scientia non olet · About LEMON Manuals